HP 3PAR Recovery Manager 2.0 Software for Microsoft Hyper-V User Guide (QL226-97701, May 2014)

Configuring RMH Server
The section describes the command line usage and parameters for configuring Hyper-V servers.
Add-HyperV
Add-HyperV adds Hyper-V credentials for users. The command is used with each Microsoft
Hyper-V (cluster or standalone host) credentials and managed by the application.
Add-HyperV command completes when specifying <WORKGROUP or HOST NAME>\<USERNAME>
format as username.
Preconditions
• User must first log on with Login-Rmh
• Hyper-V name (or synonym) just not already exist
Syntax
Any optional parameters are enclosed in square brackets [ ] around them.
Add-HyperV -RmhServerName <RmhServerName> -HypervName <HypervName>
-HypervUsername <HypervUser> -HypervPassword <HypervPassword> [-Verbose]
Table 22 Add-HyperV parameters
DescriptionOptional/RequiredParameter
Host name of the RMH Server. This is
FQDN or IP address.
Required-RmhServerName
Hyper-V host or cluster name. This is
FQDN or IP address. Synonyms are
checked. The localhost is not supported.
Required-HypervName
Hyper-V username. If cluster, ensure all
controller nodes in the cluster have the
Required-HypervUsername
same username. If not specified, a
dialog box will be presented to enter
credentials.
User name format: <WORKGROUP or
HOST NAME>\<USERNAME>.
Hyper-V password. If cluster, ensure all
controller nodes in the cluster have the
Required-HypervPassword
same password. If not specified, a
dialog box will be presented to enter
credentials.
Displays progress messages.Optional-Verbose
Add-StoreServ
Add-StoreServ is used for each HP 3PAR StoreServ credentials.
• HP 3PAR StoreServ credentials are associated to a specific Microsoft Hyper-V
• This command is only required to initially set up credentials. The command is persisted by
RMH Server until the user removes it.
• The user can Add/Remove/Update HP 3PAR StoreServ credentials at any time during the
session
56 Using PowerShell Snap-in Command Line Interface