HP 3PAR Recovery Manager 2.0 Software for Microsoft Hyper-V User Guide (QL226-97701, May 2014)

Table 50 Mount-vCopy parameters (continued)
DescriptionOptional/RequiredParameter
NOTE: If not specified, VVs will be
exported to host by Storage System, but
no mount points will be used. You will
need to access VVs using their volume
guid path (example:
\\?\Volume(wwn)\).
Specifies the virtual hard disk name,
virtual volume name, or virtual volume
Optional-Select
WWN in a comma-separated list. For
virtual hard disk name, this is the full
filename with path, or just a partial
name. Wildcards are not allowed. By
default, RMH will mount all Virtual
Copy volumes in a VCS.
Hyper-V host name. Use this option to
specify host node in cluster. You may
Optional-HypervHostName
also use this option in a non-cluster
environment. If not specified, host name
of the RMH Server is used
fromLogin-Rmh.
Displays progress messages.Optional-Verbose
Result with Description
• {RmhMountVirtualCopySetResult} has the following descriptions:
◦ RmhMountVirtualCopySet with current state updated.
◦ Information on name, WWN, partition, volume guid path, and mount point of each Virtual
Volume mounted.
Success Paths
• Scenario 1: Mount is successful.
Mount is successful.
Failure Paths
• Scenario 1: Session owner is invalid.
Every session command received on RMH Server is validated to originate from the same IP
address that initiated the session. If IP does not match, the command fails.
• Scenario 2: Storage System session credentials are not provided.
Storage System session credentials are not provided for this command.
• Scenario 3: License is missing for RMH.
License is missing for RMH.
• Scenario 4: Storage System host is not available to mount Virtual Volume(s).
A Storage System host must be available to mount Virtual Volume(s).
• Scenario 5: One or more Virtual Volumes mount points already exist.
Using specified mount point prefix and RMH format of RMH.vv-wwn, the mount point attempted
is already in use.
Mount-vCopy 87