HP 3PAR Recovery Manager 2.0 Software for Microsoft Hyper-V User Guide (QL226-97701, May 2014)

Table 53 Remove-StoreServ parameters
DescriptionOptional/RequiredParameter
Host name of the RMH Server. This is
FQDN or IP address.
Required-RmhServerName
This is FQDN or IP address. Synonyms
for Hyper-V are supported. The
localhost is not supported.
Required-HypervName
Synonyms for HP 3PAR StoreServ are
supported.
Required-StoreServName
Displays progress messages.Optional-Verbose
Success Paths
• Scenario 1: Remove Storage System is successful.
Remove operation is successful.
Failure Paths
• Scenario 1: Session owner is invalid.
Every session command received on RMH Server is validated to originate from the same IP
address that initiated the session. If IP does not match, the command fails.
• Scenario 2: Not previously added.
Storage System specified is not previously added.
Remove-vCopy
Remove-vCopy removes a Virtual Copy.
Preconditions
The user must first login with Login-Rmh.
Post Conditions
• Virtual Copy removed and all available Virtual Volumes deleted, or
• Virtual Copy retained due to at least one Virtual Volume failing to delete with reason other
than not found on storage system.
Syntax
Any optional parameters require square brackets [ ] around them.
Remove-vCopy -RmhServerName <RmhServerName> [-HypervName] -VcNameUuid
<VcNameUuid> -VmNameUuid <VmNameUuid> [-Timestamp] [-Force] [-Verbose]
Table 54 Remove-vCopy parameters
DescriptionOptional/RequiredParameter
Host name of the RMH Server. This is
FQDN or IP address.
Required-RmhServerName
Optionally select Hyper-V host/cluster
to use. This is FQDN or IP address.
Optional-HypervName
Synonyms for Hyper-V are supported.
The localhost is not supported.
Select VC by name/uuid.Required-VcNameUuid
90 HP 3PAR Recovery Manager for Microsoft Hyper-V Powershell Commands