HP 3PAR Recovery Manager 4.5.0 Software for Microsoft Exchange 2007, 2010, and 2013 User Guide

Figure 10 HP 3PAR Recovery Manager for Exchange User Account Properties
e. Click Apply and then select OK. You must restart the service when asked for.
NOTE: These changes must be done on all the servers wherever the HP 3PAR Recovery
Manager for Exchange is running.
Setting Up the Symantec Backup Exec
To use Symantec Backup Exec with HP 3PAR Recovery Manager, either remote administrator
console or typical setup (that is media server, administrator console) must be installed on HP 3PAR
Recovery Manager for Exchange backup server. Device must be configured in Backup Exec for
backup.
1. Open Symantec Backup Exec administrator console.
2. From the tool bar, select the device you want to backup.
3. To configure the device for backup, follow the onscreen instructions.
Using Your Backup Software
• The default mount point for virtual copy backups is:
<system drive>:\3parSnapshot
• You must manually synchronize backups. If a backup expires in your backup software, you
must manually remove the backup from HP 3PAR Recovery Manager. If you remove a valid
backup from HP 3PAR Recovery Manager, you must manually remove it from your backup
software.
38 Configuring Backup Software