3PAR VSS Provider 2.1.0 for Microsoft Windows User's Guide (QL226-96144, August 2011)

Table 3 Application Events (continued)
ActionDescriptionEvent ID
message indicates VSS has released the VSS Provider for Microsoft
Windows from the VSS control.
NoneSnapshot ID <snapshot_ID> prepared.5020
Internal logging, <snapshot_ID>. is a unique identifier.
NoneSnapshotSet <snapshot_set> created.5040
Indicates the SnapshotSet request has been fulfilled.
NoneExec: <message>5041
Internal logging, which records the task from the VSS Provider for
Microsoft Windows to the HP 3PAR Storage System.
NoneVirtual Copy <virtual_copy_number> exported.5042
A point-in-time snapshot disk has been created and exported to the
host.
NoneVirtual Copy <virtual_copy_ID> removed.5043
The exported snapshot disk has been removed from the host.
The request is unsupported by the
current release. Contact your local
service provider for a future release.
Unsupported feature <feature_ID>.
The VSS Provider for Microsoft Windows received an unsupported
request through the VSS framework.
5050
Reduce the number of snapshot
requests in one snapshot set to less
than 64, and request again.
A snapshot in one set has exceeded the maximum limitation.
VSS Provider for Microsoft Windows supports up to 64 snapshots
in one set. This request has exceeded the maximum limitation.
5051
Insufficient memory is available to
allow VSS Provider for Microsoft
Could not allocate memory.
Internal error, failed to allocate memory during computing.
5052
Windows to operate normally.
Shutdown some of the idle
applications that are still running and
resume the previously failed task.
See “System Setup” (page 10), to
check for CLI installation.
Could not communicate with InForm CLI.
The initial check on the InForm CLI configuration has generated an
error. This could mean several thing went wrong:
5053
• the InForm CLI is not installed.
• A valid password file could not be found or its contents are not
valid for this installation.
Correct the error and retry again, or
contact your local service provider if
the error continues.
<message>
This is an error message that usually is associated with Event ID
5041. This event describes the cause to the action on Event ID 5041.
5054
Set the LogLevel to ‘4’ to show the
detail error message to log file, and
retry.
<token_ID>: Invalid token.
Internal error. The output format does not match.
5055
Set the LogLevel to ‘4’ and look for
vvmap as <some_file_name> from
the 3parprov.log.
Could not open the volume mapping file: <mapping_file>. Failed
to open the mapping file that is generated by the showvv –d CLI
command.
5056
Look for file <filename> to see the
if the permissions are set correctly.
Could not open file: <filename>
The VSS Provider for Microsoft Windows failed to open the
temporary file <filename> that is generated internally.
5057
22 Diagnostics