HP 3PAR Management Console 4.5.1 Software User Guide

DescriptionFieldGroup
For RCIP ports. The MAC address of the Ethernet interface.MACIP Settings
(displayed for
For iSCSI ports. Indicates if the DHCP protocol is enabled.DHCP
RCIP and
iSCSI ports -
not shown)
IP address of the iSCSI or RCIP port.IP Address
The address of a local IP router on the same network as the system, used to forward
traffic to destinations beyond the local network.
Gateway
The netmask address for the iSCSI or RCIP interface.Subnet Mask
The greatest amount of data or "packet" size that can be transferred at one time
over a particular network connection without overburdening the connection. The
MTU
default MTU setting for an iSCSI port is 1500. When supported by the network,
an MTU value of 9000 should be used.
For RCIP ports. The configured data transfer rate. A value of 0 indicates that no
data is being transferred.
Configured Rate
For iSCSI ports. Data transfer rate. A value of 0 indicates that no data is being
transferred.
Rate
The TCP port number used by the iSCSI card.TCP Port
(For RCIP) The duplex speed, Half or Full.Duplex
For RCIP ports. Model of the adapter that contains the port (for example, Intel
PRO/1000MT).
Adapter Type
Type of connection (for example, Fabric Attached).TopologyFibre Channel
Settings
Identifies which Fibre Channel classes of service are enabled (2, 3, or 2/3). 2/3
indicates that both Class 2 and Class 3 are enabled.
Class
(displayed for
FC and RCFC
ports)
Model of the Fibre Channel adapter that contains the port (for example, QLOGIC
2302).
Adaptor Type
The node WWN. Displayed if the port is an RCFC port.Remote Node
WWN
The port WWN. Displayed if the port is an RCFC port.Remote Port WWN
Indicates whether port mode change from initiator to target or vice versa is Allowed
or Prohibited. This setting is configured using the CLI controlport command.
Mode Change
The number of hosts connected to the port. This is only displayed if the port is
connected to hosts.
Hosts
The number of physical disks connected to the port. This is only displayed if the
port is connected to drive cages.
Physical Disks
The current state of the link. Displayed if the port is an RCFC port.Link State
Primary Internet Storage Name Service server IP address. iSNS protocol allows
for automated discovery, management, and configuration of iSCSI.
Primary IP AddressiSNS Settings
(displayed for
iSCSI ports -
not shown)
The port on the iSNS server with which to communicate.TCP Port
The number of NPIV ports.NPIV PortsNPIV Ports
(displayed for
FC Peer ports)
The WWN of each NPIV port.Port WWN
Click the highlighted value for Connected Device in the General area to display the Host Summary
screen or the System screen, depending on the connected device type.
270 Using Peer Motion in HP 3PAR Management Console Manager