Manualshelf

HP 3PAR Management Console 4.5.1 Software User Guide

ManualsBrandsHP ManualsSoftwareHP 3PAR Operating System Software
21222324252627282930
1. In the Manager Pane, select Systems.
2. In the Management Tree, select the system on which you want to configure the port.
3. In the Common Actions panel, click Configure iSCSI Port. The iSCSI Port Configuration wizard
appears.
General
1. In the General group box:
a. System list - Select the system on which the port will be configured.
b. Port list - Select the port to be configured as an RCIP port.
2. In the IP Settings group box, perform the following:
a. Select Obtain an IP Address automatically.
b. MTU list - Enter the MTU (maximum transmission units) value.
or
c. Select Use the following IP address.
d. IP Address - Enter the iSCSI port's IP address.
e. Subnet Mask - Enter the iSCSI port's subnet mask.
f. Gateway - Enter the iSCSI port's gateway address.
g. MTU list - Enter the MTU (maximum transmission units) value.
3. Click Finish to complete the iSCSI port configuration, or click Next to enter iSNS settings.
iSNS Settings
1. Primary IP Address – (Optional) Enter the Internet Storage Name Service (iSNS) IP address.
2. Secondary IP Address – (Optional) Enter the Secondary IP Address.
3. TCP Port – (Optional) Enter the iSNS TCP port. The default port is 3205.
4. Click Finish to complete the iSCSI port configuration, or click Next to view the configuration
summary.
Summary
Review the summary information. When satisfied, click Finish.
Configuring an RCFC Port
To configure a Remote Copy over Fibre Channel (RCFC) port, access the Fibre Channel Port
Configuration dialog:
1. In the Manager Pane, select Systems.
2. In the Management Tree, select the system on which you want to configure the port.
3. In the Common Actions panel, click Configure FC Port.
The Fibre Channel Port Configuration dialog appears.
4. In the General group box:
a. System list - Select the system on which the port will be configured.
b. Port list - Select the port to be configured as a Fibre Channel port.
5. In the Settings group box:
a. Connection Mode list - Select the mode of the port as RCFC.
b. Connection Type list - Select whether the connection type is Loop or Point.
c. Unique Node WWN - Enable or disable the node WWN.
d. Configured Rate - Select Auto (default), 1 Gbps, 2 Gbps, or 4 Gbps.
e. VLUN Change Notification (VCN) - Enable or disable the VLUN (Virtual Logical Unit
Number) change notification.
f. Interrupt Coalesce - Enable or disable the interrupt coalesce.
Configuring Ports 29