HP 3PAR Management Console 4.5.1 Software User Guide

The following information is provided:
DescriptionColumn
Physical disk ID, as assigned by the system. For unadmitted disks, this columns is blank
(--).
ID
Location of the disk in C:M:D (Cage:Magazine:Disk) format.Position
The World Wide Name assigned to the disk.WWN (for non-SAS drives)
The device name assigned to the disk.WWN/Device Name (for DCS1
and DCS2 drive cages)
Current state of the disks.Status LED (for DC1, DC2, and
DC4 drive cages)
Current internal temperature of the disk drive.Temperature
The loop A arbitrated loop physical address of the disk.Loop A AL_PA
Status of the Interface Card loop to the node. See “System and Component Status
Icons” (page 507).
Loop A State
The loop B arbitrated loop physical address of the disk.Loop B AL_PA
Status of the Interface Card loop to the node. See “System and Component Status
Icons” (page 507).
Loop B State
Status of the physical disk. See “System and Component Status Icons” (page 507) .State (for DCS1 and DCS2
drive cages).
Viewing Drive Cage Power Supply Details
To view power supply details:
1. Navigate to the Drive Cages screen.
2. In the list pane of the Drive Cages screen, click the Summary tab and select a drive cage.
3. In the detail pane, click the Power Supplies tab.
The Power Supplies tab appears as follows (the following depicts information for a DC2 drive
cage. Your screen might differ depending on the drive cage type in your system):
Viewing Drive Cages 333