HP 3PAR Management Console 4.5.1 Software User Guide

2. In the Management Window, click the CNA tab.
The CNA tab is divided into a list pane and a detail pane. The list pane displays a summary of all
CNA ports in the system. The detail pane displays detailed information about a single port selected
from the list pane.
List Pane
The following information is provided:
DescriptionColumn
The port location in Node:Slot:Port format.Position
World Wide Name or Media Access Control address of the connected device.WWN/MAC
The state of the port. See “System and Component Status Icons” (page 507).State
The port protocol type.Type
Type of device that the port is connected to. Free, Disk, Host, Peer, RC, or InServ.Connected Device Type
Name of device that the port is connected to, for example, host1, cage0.Connected Device
Port firmware mode setting—Initiator, Target, Peer, or Suspended. Ports in Initiator mode
are connected to drive cages and ports in Target mode export to hosts. Suspended
Mode
mode is for target ports that have not yet been initialized by the system (rare). Peer
mode is for Ethernet ports.
The partner port.Partner
The WWN of the partner port.Partner WWN
Indicates if the system is in a failover state.Failover State
Detail Pane
The detail pane provides detailed information about a selected CNA port from the list pane.
Summary, Sessions, and Host tabs are displayed for iSCSI-configured ports. The information on
these tabs is identical to that displayed on corresponding tabs for iSCSI ports: “iSCSI Port Summary
Tab” (page 52), “Sessions Tab” (page 53), and “Hosts Tab” (page 53).
42 Managing Ports