HP 3PAR Management Console 4.5.1 Software User Guide

The following information is provided:
DescriptionFieldGroup
The port location in Node:Slot:Port format.PositionGeneral
The designated port label.Label
Port World Wide Name.Port WWN
Node World Wide Name.Node WWN
Indicates whether the port is FC, iSCSI, RCIP, or RCFC.Type
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or
4 Gbps). When there is no specified value, no connection exists.
Rate
Type of device that the port is connected to: Free, Disk, Host, Peer,
or InServ.
Connected Device Type
Name of device that the port is connected to, for example, host1,
cage0.
Connected Device
Port firmware mode setting. Ports in Initiator mode are connected to
drive cages and ports in Target mode export to hosts. Suspended
Mode
mode is for target ports that have not yet been initialized by the
system (rare). Peer mode is for Ethernet ports.
Current state of the port.State
The throughput in KB/s.Total Data ThroughputResources
The type of port connection.Connection ModeSettings
Connection type or port connection setting (Loop, Point, or
Loop-point). When the port is set to Loop-point, both loop and
point-to-point connections are enabled.
Connection Type
Data transfer rate setting (for example, 1 Gbps). Auto indicates that
the system automatically selects the rate.
Configured Rate
Maximum rate of connection from the port.Max Rate
Indicates whether Fibre Channel service Class 2 is Disabled, Ack 1
or Ack 0.
Class 2
For fabric attached ports, indicates the VLUN change notification
setting. When set to Enabled, notices are generated and sent to the
fabric controller. When set to Disabled, no notification is sent.
VCN
Indicates whether the node's WWN is Enabled or Disabled. Not
available for systems running HP 3PAR OS 2.2.4 or earlier.
Unique Node WWN
If Disabled, each I/O generates a separate interrupt to the HBA port
driver rather than generating one interrupt for multiple I/O
Interrupt Coalesce
completion. Not available for systems running HP 3PAR OS 2.2.4
or earlier.
Type of connection (Private Loop, Public Loop, or Point-Point).TopologyFibre Channel
Settings
Identifies which Fibre Channel classes of service are enabled (2, 3,
or 2/3). 2/3 indicates that both Class 2 and Class 3 are enabled.
Class
Model of the Fibre Channel adapter that contains the port (for
example, QLOGIC 2302).
Adaptor Type
World Wide Name of the remote port.Remote Port WWN
World Wide Name of the remote node.Remote Node WWN
Viewing System Ports 49