HP 3PAR Management Console 4.5.1 Software User Guide

DescriptionFieldGroup
Indicates whether port mode change from initiator to target or vice
versa is Allowed or Prohibited. This setting is configured using the
HP 3PAR CLI command controlport.
Mode Change
The state of the link.Link State
Number for the current port persona setting.PersonaPersona (not
displayed on
Manufacturer of the host computers network adapter. This value is
determined by the port persona.
Vendor
systems using HP
3PAR OS 2.3.1 or
later)
Host computer's network adapter. This value is determined by the
port persona.
Adapter Type
Host computers operating system. This value is determined by the
port persona.
OS
Indicates whether the connection is Direct Connect or Fabric
Attached, as determined by the port persona.
Connection
When a persona has been edited by a user, Modified appears in
this column. Otherwise, this column remains blank (--).
Modified
SFP Tab
The RCFC SFP information is displayed on the SFP tab.
The following information is provided:
DescriptionFieldGroup
The location of the SFP within the system.PositionGeneral
Current condition of the SFP.State
Manufacturer of the SFP.Manufacturer
Part number of the SFP.Part Number
Serial number of the SFP.Serial Number
SFP's revision level.Revision
Maximum speed allowed by the SFP.Max Speed
Displays whether the SFP has been tested and if the SFP is supported.Qualified
Displays whether the transmit laser is disabled.TX Disable
Displays whether the transmit laser has a problem.TX Fault
Displays whether the receive end of the SFP is experiencing a loss
of signal from the host or drive cage.
RX Loss
Displays whether the SFP receive power is low.RX Power Low
Displays whether the SFP is DDM-capable (Digital Diagnostic
Monitoring).
DDM Support
Identifies the monitored parameters (temperature, voltage, TX bias,
TX power, and RX power).
TypeDDM
The unit of measure used for the monitored parameters.Unit
The current measured value.Value
The manufacturer's recommended lower-limit warning level.Low Threshold Warning
The manufacturer's recommended upper-limit warning level.High Threshold Warning
50 Managing Ports