HP 3PAR OS 3.1.3 Command Line Interface Reference

Use this specifier to block until all the copies are complete. Without this option, the command
completes before the copy operations are completed (use the showvv command to check the status
of the copy operations).
-pri <high|med|low>
Specifies the priority of the copy operation when it is started. This option allows the user to control
the overall speed of a particular task. If this option is not specified, the creategroupvvcopy
operation is started with default priority of medium. High priority indicates that the operation will
complete faster. Low priority indicates that the operation will run slower than the default priority
task. This option cannot be used with -halt option.
SPECIFIERS
<destination_VV>
Indicates the destination virtual volume.
<parent_VV>
Indicates the parent virtual volume.
RESTRICTIONS
None
NOTES
• The creategroupvvcopy command can be issued multiple times. However, the HP 3PAR
Storage System allows only two active physical copy tasks to run concurrently. Any additional
physical copy tasks are queued, pending the completion of the active physical copy tasks.
• Consistent group snapshots are all created at the same point in time so that related structures
on different volumes in the group remain consistent.
creategroupvvcopy 111