HP 3PAR OS 3.1.3 Command Line Interface Reference

17 Locate Commands
locatecage
DESCRIPTION
The locatecage command allows system administrators to locate a drive cage, drive magazine,
or port in the system using the devices’ blinking LEDs.
SYNTAX
The syntax for the locatecage command can be one of the following:
• To locate an entire drive cage:
locatecage [option <arg>] <cage_name>
• To locate a drive magazine:
locatecage [option <arg>] <cage_name> <mag>
• To locate a port:
locatecage [option <arg>] <cage_name> <port_name>
AUTHORITY
• Super, Service
• Any role granted the cage_locate right.
NOTE: You need access to all domains in order to run this command.
OPTIONS
–t <sec>
Specifies the number of seconds, from 0 through 255 seconds, to blink the LED. If the argument is
not specified, the option defaults to 60 seconds.
SPECIFIERS
<cage_name>
Specifies the drive cage name as shown in the Name column of showcage command output.
<port_name>
Indicates the port specifiers. Accepted values are A0|B0|A1|B1|A2|B2|A3|B3. If a port is
specified, the port LED will oscillate between green and off. The <port_name> specifier is not
supported for DC3 drive cages.
<mag>
Indicates the drive magazine by number.
• For DC1 drive cages, accepted values are 0 through 4.
• For DC2 and DC4 drive cages, accepted values are 0 through 9.
• For DC3 drive cages, accepted values are 0 through 15.
RESTRICTIONS
• Access to all domains is required to run this command.
• The <port_name> specifier is not supported for DC3 drive cages.
locatecage 189