HP 3PAR OS 3.1.3 Command Line Interface Reference

it must be used at least once on the command line. If this specifier is repeated then the operation
is performed on multiple disks.
RESTRICTIONS
Access to all domains is required to run this command.
EXAMPLES
The following example moves chunklets that were on PD 8 that were relocated to another position,
back to PD 8:
cli% moverelocpd 8
Are you sure you want to move the chunklets ?
select q=quit y=yes n=no: y
Move -Status- -Detailed_State-
42:51-8:2 normal normal
62:50-8:1 normal normal
62:53-8:4 normal normal
62:57-8:7 normal normal
64:49-8:0 normal normal
88:52-8:3 normal normal
88:55-8:6 normal normal
90:55-8:5 normal normal
The columns in the previous example are identified as follows:
• Status. The overall status of the move.
• normal. Indicates the chunklet has successfully moved with no loss of quality.
• degraded. Indicates the chunklet has successfully moved with loss of quality.
• failed. Indicates the chunklet was not moved.
• Detailed_State. Provides additional details of the move with General Information, Error
Information, or Degraded Information.
General Information:
• dest_unknown. Destination is unknown.
• dest_unknown. Destination is known.
• valid_move. Source and Destination are valid.
• ch_moved. Chunklet was moved.
• ch_move_pending. Chunklet move is pending due to -nowait option.
• move_error. Error moving chunklet.
Error Information:
• error_type_unknown. An unknown error occurred.
• spares_not_found. No suitable spares available.
• duplicate_src. Duplicate source input.
• duplicate_dest. Duplicate destination in chunklet list.
• src_relocating. Source is relocating.
• ch_synching. Chunklet is synchronizing.
• src_no_ld. Source not associated with an LD.
• src_ld_invalid. Source associated with invalid LD.
204 Move Commands