HP 3PAR OS 3.1.3 Command Line Interface Reference

20 Remove Commands
removealert
DESCRIPTION
The removealert command removes one or more alerts from the system.
CAUTION: Use care when removing alerts. Alerts that have not been fixed or acknowledged
should not be removed.
SYNTAX
removealert [option] –a|<alert_ID>...
AUTHORITY
• Super, Service
• Any role granted the alert_remove right.
NOTE: You need access to all domains in order to run this command.
OPTIONS
–a
Specifies all alerts from the system and prompts removal for each alert. If this option is not used,
then the <alert_ID> specifier must be used.
–f
Specifies that the command is forced. If this option is not used and there are alerts in the new state,
the command requires confirmation before proceeding with its operation.
SPECIFIERS
<alert_ID>...
Indicates a specific alert be removed from the system. This specifier can be repeated to remove
multiple alerts. If this specifier is not used, the –a option must be used.
RESTRICTIONS
Access to all domains is required to run this command.
EXAMPLES
The following example displays all alerts from the system with the option to remove individual
alerts:
cli% removealert –a
Id 120 – New
Occurred 4 times, last at Tue May 03 22:45:47 PDT 2005
Message code: 196609
Tue May 03 22:23:17 PDT 2005
Node: 0 Severity: Minor
Firmware coredump event
Firmware COREDUMP: recovered file /var/core/hba/fwcore.n00.s02.p01.20050503.224547
Alert 120 is marked as "New".
removealert 213