HP 3PAR OS 3.1.3 Command Line Interface Reference

–nd <item>
Specifies one or more nodes. Nodes are identified by one or more integers (item). Multiple nodes
are separated with a single comma (1,2,3). A range of nodes is separated with a hyphen (0–7).
The primary path of the disks must be on the specified node(s).
–st <item>
Specifies one or more PCI slots. Slots are identified by one or more integers (item). Multiple slots
are separated with a single comma (1,2,3). A range of slots is separated with a hyphen (0–7).
The primary path of the disks must be on the specified PCI slot(s).
–pt <item>
Specifies one or more ports. Ports are identified by one or more integers (item). Multiple ports
are separated with a single comma (1,2,3). A range of ports is separated with a hyphen (0–4).
The primary path of the disks must be on the specified port(s).
–cg <item>
Specifies one or more drive cages. Drive cages are identified by one or more integers (item).
Multiple drive cages are separated with a single comma (1,2,3). A range of drive cages is
separated with a hyphen (0–3). The specified drive cage(s) must contain disks.
–mg <item>
Specifies one or more drive magazines. The 1. or 0. displayed in the CagePos column of showpd
output indicating the side of the cage is omitted when using -mg option. Drive magazines are
identified by one or more integers (item). Multiple drive magazines are separated with a single
comma (1,2,3). A range of drive magazines is separated with a hyphen (0–3). The specified
drive magazine(s) must contain disks.
–pn <item>
Specifies one or more disk positions within a drive magazine. Disk positions are identified by one
or more integers (item). Multiple disk positions are separated with a single comma (1,2,3). A
range of disk positions is separated with a hyphen (0–3). The specified position(s) must contain
disks.
–dk <item>
Specifies one or more physical disks. Disks are identified by one or more integers (item). Multiple
disks are separated with a single comma (1,2,3). A range of disks is separated with a hyphen
(0–3). Disks must match the specified ID(s).
NOTE: The following options are used to select the disks that are used to create common
provisioning groups based on the characteristics of the disk.
–tc_gt <number>
Specifies that physical disks with total chunklets greater than the number specified are selected.
–tc_lt <number>
Specifies that physical disks with total chunklets less than the number specified are selected.
–fc_gt <number>
Specifies that physical disks with free chunklets greater than the number specified are selected.
–fc_lt <number>
Specifies that physical disks with free chunklets less than the number specified are selected.
–devid <model>
Specifies that physical disks identified by their models are selected. Models can be specified in a
comma-separated list. Models can be displayed by issuing the showpd -i command.
–devtype <type>
276 Set Commands