HP 3PAR OS 3.1.3 Command Line Interface Reference

setlicense
DESCRIPTION
The setlicense command sets the license key information.
SYNTAX
setlicense [options <arg>]
AUTHORITY
• Super, Service
• Any role granted the license_set right.
NOTE: You need access to all domains in order to run this command.
OPTIONS
–f <filename>
Specifies the file from which the license key is read.
–noconfirm
Specifies that the system does not prompt for confirmation for the new license key.
SPECIFIERS
None
RESTRICTIONS
• Access to all domains is required to run this command.
• The entered license key is accepted only if it is recognized as a valid key. A valid license key
includes an appropriate serial number and is associated with the number of nodes in the
system for which the license key is being entered.
• HP 3PAR’s license terms and conditions must be accepted before proceeding with this
command.
EXAMPLES
The following example displays the setting of a license key:
cli% setlicense
If this software is being provided to you for a limited evaluation period, then your
license shall be governed by the current HP Software License Terms (or as otherwise
agreed between us) with the exception that the term of the license shall expire upon
the earlier of the evaluation period notified to you or 120 days. Upon expiration of
the license, you must cease using the software and HP reserves the right to disable
the software without notice. By using or activating the software you are agreeing to
these terms.
Do you agree to these terms and conditions? y=yes n=no: yes
Please enter the new license key below. When finished, press enter twice. If the key
is entered by hand, note that characters other than letters and numbers are ignored,
and the key is not case-sensitive.
60R3–0C1G...
288 Set Commands