HP 3PAR OS 3.1.3 Command Line Interface Reference

inc
Sort in increasing order (default).
dec
Sort in decreasing order.
Multiple columns can be specified and separated by a colon (:). Rows with the same information
in them as earlier columns will be sorted by values in later columns.
–p <pattern>
Specifies a pattern for disks. Patterns are used to select disks that are used for creating LDs. If no
pattern is specified, the option defaults to all Fibre Channel (FC) disks. If specified multiple times,
each instance of the specified pattern adds additional candidate disks matching the pattern. The
-devtype pattern cannot be used to mix Near Line (NL), FC and SSD drives.
NOTE: An item is specified as an integer, a comma-separated list of integers, or a range of
integers specified from low to high.
–nd <item>
Specifies one or more nodes. Nodes are identified by one or more integers (item). Multiple nodes
are separated with a single comma (1,2,3). A range of nodes is separated with a hyphen (0–7).
The primary path of the disks must be on the specified node(s).
–st <item>
Specifies one or more PCI slots. Slots are identified by one or more integers (item). Multiple slots
are separated with a single comma (1,2,3). A range of slots is separated with a hyphen (0–7).
The primary path of the disks must be on the specified PCI slot(s).
–pt <item>
Specifies one or more ports. Ports are identified by one or more integers (item). Multiple ports
are separated with a single comma (1,2,3). A range of ports is separated with a hyphen (0–4).
The primary path of the disks must be on the specified port(s).
–cg <item>
Specifies one or more drive cages. Drive cages are identified by one or more integers (item).
Multiple drive cages are separated with a single comma (1,2,3). A range of drive cages is
separated with a hyphen (0–3). The specified drive cage(s) must contain disks.
–mg <item>
Specifies one or more drive magazines. The 1. or 0. displayed in the CagePos column of showpd
output indicating the side of the cage is omitted when using the -mg option. Drive magazines are
identified by one or more integers (item). Multiple drive magazines are separated with a single
comma (1,2,3). A range of drive magazines is separated with a hyphen (0–7). The specified
drive magazine(s) must contain disks.
–pn <item>
Specifies one or more disk positions within a drive magazine. Disk positions are identified by one
or more integers (item). Multiple disk positions are separated with a single comma (1,2,3). A
range of disk positions is separated with a hyphen (0–3). The specified drive position(s) must
contain disks.
–dk <item>
Specifies one or more PDs. Disks are identified by one or more integers (item). Multiple disks are
separated with a single comma (1,2,3). A range of disks is separated with a hyphen (0–3). Disks
must match the specified ID(s).
NOTE: The following arguments, –tc_gt , –tc_lt , –fc_gt , –fc_lt , –devid , and –devtype are used
to limit the disks that are used to create logical disks based on the characteristics of the disk drive.
424 Show Commands