HP 3PAR OS 3.1.3 Command Line Interface Reference

shutdownsys
DESCRIPTION
The shutdownsys command shuts down an entire system.
SYNTAX
shutdownsys halt|reboot
AUTHORITY
• Super, Service
• Any role granted the sys_shutdown right.
NOTE: You need access to all domains in order to run this command.
SUBCOMMANDS
halt
Specifies that the system should be halted after shutdown. If this subcommand is not specified, the
reboot subcommand must be used.
reboot
Specifies that the system should be restarted after shutdown. If this subcommand is not specified,
the halt subcommand must be used.
OPTIONS
None
SPECIFERS
None
RESTRICTIONS
• Access to all domains is required to run this command.
• Do not issue any commands other than showsys while the system is shutting down.
EXAMPLES
The following example shuts down and then restarts the system:
cli% shutdownsys reboot
-----System Information-----
System Name : ma1tp001
System Model : InServ S800X
Serial Number : 1000787
-------------------Partial List Of Hosts--------------------
Id Name Persona -WWN/iSCSI_Name- Port IP_addr
0 sunx4150-01 Generic-legacy 2101001B32343495 6:5:1 n/a
1 sunx4150-02 Generic-legacy 2101001B32344695 6:5:1 n/a
2 sunx4150-03 Generic-legacy 2100001B32147595 6:5:1 n/a
3 sunx4150-04 Generic-legacy 2101001B32341C95 6:5:1 n/a
4 sunx4150-05 Generic-legacy 2101001B32342495 6:5:1 n/a
5 sunx4150-06 Generic-legacy 2100001B321A6E82 6:5:1 n/a
6 sunx4150-07 Generic-legacy 2101001B3231EE79 6:5:1 n/a
shutdownsys 525