HP 3PAR OS 3.1.3 Command Line Interface Reference

–sortcol <col> [,<dir>][:<col>[,<dir>]...]
Sorts command output based on the column number (<col>). Columns are numbered from left to
right, beginning with 0. At least one column must be specified. In addition, the direction of sorting
(<dir>) can be specified as follows:
inc
Sort in increasing order (default).
dec
Sort in decreasing order.
Multiple columns can be specified separated by a colon (:), Rows that have the same information
in them as earlier columns will be sorted by the values in the later columns.
–filt <fspec>
Specifies that statistics that fall below the threshold as specified by the <fspec> arguments where
<fspec> is <type>, <op>, <meas>, <val>, are filtered out and not displayed. The type,
operation, meas, andvalue arguments are separated with one comma.
• <type>
The type argument can be specified with one of the following arguments:
◦ curs
Specifies that only devices with current statistics above the threshold are displayed.
◦ avgs
Specifies that only devices with average statistics above the threshold are displayed.
◦ maxs
Specifies that only devices with maximum values above the threshold are displayed.
• <op>
The operation argument can be specified with one of the following arguments:
◦ r
Specifies that read-only statistics are displayed.
◦ w
Specifies that write-only statistics are displayed.
◦ t|rw
Specifies that statistics for read and write totals are displayed.
• <meas>
The meas argument can be specified with one of the following arguments:
◦ iops
Specifies that I/O operations per second are displayed. If this argument is used, the
minimum threshold value must be specified using the <val> argument.
◦ bw
Specifies that statistics for bandwidth in bytes per second are displayed. If this argument
is used, the minimum threshold value must be specified using the <val> argument.
statpd 615