HP 3PAR OS 3.1.3 Command Line Interface Reference

◦ svct
Specifies that statistics for service time in milliseconds are displayed.
◦ size
Specifies that statistics for I/O operations in bytes are displayed.
• <val> [k|K]|[m|M]|[g|G]
Specifies the minimum threshold using any integer. The integer can optionally be followed
with k or K to indicate a multiple of 1000, m or M to indicate a multiple of 1,000,000, or
g or G to indicate a multiple of 1,000,000,000.
An example of this option in use is –filt curs,r,iops,10k that indicates that statistics for a
device that has more than 10,000 current read-only I/O operations are displayed.
–ni
Specifies that statistics for only non-idle devices are displayed. This option is shorthand for the
option –filt curs,t,iops,0.
–p <pattern>
Specifies that statistics for a pattern of PDs are displayed. Patterns are used to filter and select the
disks from which the statistics are collected. If specified multiple times, each instance of the specified
pattern adds additional candidate disks matching the pattern:
NOTE: An item is specified as an integer, a comma-separated list of integers, or a range of
integers specified from low to high.
–nd <item>
Specifies one or more nodes. Nodes are identified by one or more integers (item). Multiple nodes
are separated with a single comma (1,2,3). A range of nodes is separated with a hyphen (0–7).
The primary path of the disks must be on the specified node(s).
–st <item>
Specifies one or more PCI slots. Slots are identified by one or more integers (item). Multiple slots
are separated with a single comma (1,2,3). A range of slots is separated with a hyphen (0–5).
The primary path of the disks must be on the specified PCI slot(s).
–pt <item>
Specifies one or more ports. Ports are identified by one or more integers (<item>). Multiple ports
are separated with a single comma (1,2,3). A range of ports is separated with a hyphen (0–4).
The primary path of the disks must be on the specified port(s).
–cg <item>
Specifies one or more drive cages. Drive cages are identified by one or more integers (<item>).
Multiple drive cages are separated with a single comma (1,2,3). A range of drive cages is
separated with a hyphen (0–3). The specified drive cage(s) must contain disks.
–mg <item>
Specifies one or more drive magazines. The 1. or 0. displayed in the CagePos column of showpd
output indicating the side of the cage is omitted when using -mg option. Drive magazines are
identified by one or more integers (item). Multiple drive magazines are separated with a single
comma (1,2,3). A range of drive magazines is separated with a hyphen (0–7). The specified
drive magazine(s) must contain disks.
–pn <item>
Specifies one or more disk positions within a drive magazine. Disk positions are identified by one
or more integers (item). Multiple disk positions are separated with a single comma (1,2,3). A
616 Stat Commands