HP 3PAR OS 3.1.3 Command Line Interface Reference

5 seconds. If neither -w <wait> nor -c <count> is present, the timeout is the default value for

the count (1 second) plus 5 seconds, or 6 seconds. The maximum value is 30 seconds.

–s <size>

Specifies the packet size. If no size is specified, the option defaults to 64. This option and argument

can only be used with the rcip ping subcommand.

–pf

Prevents packet fragmentation when issuing the controlport rcip ping command. This option

can only be used with the rcip ping subcommand.

-portwwn <wwn>

Specifies the Fibre Channel worldwide port name of an attached device for which selective LIP

reset will be performed.

SPECIFIERS

Specifies whether the port is used for a disk, host, peer, remote copy over Fibre Channel (rcfc),

or iSCSI (iscsi), or Fibre Channel over Ethernet (fcoe) connection. This specifier must be used

when issuing the config subcommand.

<ctval>

Specifies the connection parameter of the port. Parameters can be loop or point. The loop

parameter sets the port to arbitrated loop mode, the point parameter sets the port to point-to-point

mode. This specifier must be provided when issuing the ct subcommand.

Specifies the Fibre Channel Class-2 parameter of the port. Parameters can be one of ack0, ack1,

or disable. This specifier must be provided when issuing the cl2 subcommand.

Specifies the data rate of the Fibre Channel port. Rates can be one of 1, 2, 4, or auto. 1 sets the

data rate to 1 GBps, 2 sets the data rate to 2 GBps, and 4 sets the data rate to 4 GBps. The auto

parameter sets the port to autodetect the data rate. This specifier must be used when issuing the

rate subcommand.

<port_label>

Specifies the value of the port label. The port label value is a human-readable string used for easy

identification of the port.

Specifies the value of the VCN. The VCN value can be set as enable or disable. This specifier

must be used when issuing the vcn subcommand.

Specifies the IMP port attribute. The IMP value can be set as enable or disable. This specifier

must be used when issuing the imp subcommand.

Specifies if interrupt coalescing is enabled or disabled. The value can be set as enable or

disable. This specifier must be used with the intcoal subcommand.

<node:slot:port>

Specifies the port to be controlled.

node

Specifies the node using a number between 0 and 7.

slot

controlport 93