HP 3PAR OS 3.1.3 Command Line Interface Reference

Specifies the PCI bus slot in the specified node using a number between 0 and 5.

port

Specifies the Fibre Channel port number of the PCI card in the specified PCI bus slot using 1 through

<IP_address>

Specifies the IP address for a remote-copy interface.

<gateway_address>

Specifies the gateway address for a remote-copy interface.

Specifies the netmask for a remote-copy interface.

<MTU_size>

Specifies the MTU size for a remote-copy interface using an integer from 100 to 9000. If no integer

is specified, the value defaults to 1500.

<speed> half|full

Use only with the rcipspeed subcommand. Specifies the speed setting (10, 100, or 1000 MBps)

and duplex setting (half or full) for a remote-copy interface. In addition to this specifier, you

must also specify an interface using <node:slot:port>. If no speed or duplex settings are specified,

or if you specify auto with the rcipspeed subcommand, the system auto-negotiates the speed

and duplex.

Specifies the Fibre Channel worldwide port name of an attached port. This specifier is used with

the login and logout subcommands.

-virt_ports <num_virt_ports>

Specifies the creation/removal of virtual peer ports while configuring a port using the controlport

config peer command. If the number of virtual peer ports specified is greater than the number

of existing virtual peer ports, then additional virtual peer ports will be created to match the total

<num_virt_ports>. The maximum number of virtual peer ports that can be created is 8. The

showport -peer command displays the virtual peer ports. If the number of virtual peer ports

specified is zero, then the virtual peer ports are removed.

RESTRICTIONS

• Access to all domains is required to run this command.

• The –m <mode> option for the rst subcommand cannot be specified if there are active

connections already using the port (that is the port online) except as noted in the following

section under port pair protection.

• Port pair protection:

• For dual-port LSI Fibre Channel adapters, both ports in the pair must use the same mode

(initiator or target).

94 Control Commands