HP 3PAR SmartStart 1.1 Release Notes (QR482-96033, December 2012)

ManualsBrandsHP ManualsSoftwareHP 3PAR Operating System Software

HP 3PAR SmartStart 1.1 Software

Release Notes

Abstract

The information in this document is intended for use by HP customers, partners, and HP field representatives. These release notes

describe the features in HP 3PAR SmartStart 1.1.

HP Part Number: QR482-96033

Published: December 2012

Summary of content (4 pages)

PAGE 1
HP 3PAR SmartStart 1.1 Software Release Notes Abstract The information in this document is intended for use by HP customers, partners, and HP field representatives. These release notes describe the features in HP 3PAR SmartStart 1.1.
PAGE 2
© Copyright 2012 Hewlett-Packard Development Company, L.P. Confidential computer software. Valid license from HP required for possession, use or copying. Consistent with FAR 12.211 and 12.212, Commercial Computer Software, Computer Software Documentation, and Technical Data for Commercial Items are licensed to the U.S. Government under vendor's standard commercial license. The information contained herein is subject to change without notice.
PAGE 3
1.1 Introduction This document provides the release notes for HP 3PAR SmartStart 1.1 Software. HP 3PAR SmartStart is a single startup tool that enables effortless setup of the HP 3PAR StoreServ 7000 Storage system. SmartStart guides you through configuring all the required components for starting up the HP 3PAR StoreServ 7000 Storage platform. To obtain a copy of this documentation, go to the HP 3PAR support site: http://www.hp.com/3par/support_manuals 1.
PAGE 4
1.3.4 Multiple Users Using SmartStart for the Same Task at the Same Time Can Cause Task Failure (Bug 80460) SmartStart might not be able to scan new disks or complete some host configuration steps if multiple users are using SmartStart to configure the same host or add virtual volumes to Windows at the same time. Workarounds: • Only use one instance of SmartStart at a time to connect to a host. • Delete the temporary directory on the host you are configuring (c:\Users\Public\ tmpSmartStart..