HP 3PAR SmartStart 1.1 Release Notes (QR482-96033, December 2012)

1.1 Introduction
This document provides the release notes for HP 3PAR SmartStart 1.1 Software.
HP 3PAR SmartStart is a single startup tool that enables effortless setup of the HP 3PAR StoreServ 7000
Storage system. SmartStart guides you through configuring all the required components for starting
up the HP 3PAR StoreServ 7000 Storage platform.
To obtain a copy of this documentation, go to the HP 3PAR support site:
http://www.hp.com/3par/support_manuals
1.2 Features
SmartStart guides you through:
Setting up the HP 3PAR Service Processor
Initializing the HP 3PAR StoreServ 7000 Storage system
Configuring application hosts
Creating basic storage
Installing the HP 3PAR Management Console
1.3 Known Issues with HP 3PAR SmartStart
1.3.1 SmartStart Does Not Update the iSCSI Target or Initiator IP When You Reconfigure
the IP Address (Bug 79019)
When you reconfigure an iSCSI target using the same port (the same iSCSI name) but using a different
target or initiator IP address, SmartStart does not update the IP address.
Workaround:
1. Open the Windows iSCSI Initiator Properties dialog.
2. If the target is safe to remove (in other words, not active), remove the target you want to modify.
3. Use SmartStart’s iSCSI Host Configuration wizard to configure the target from SmartStart.
1.3.2 SmartStart Does Not Create a Shortcut to the HP 3PAR Management Console for
Standard User Accounts (Bug 79283)
Because SmartStart runs as Administrator, SmartStart does not create HP 3PAR Management Console
program shortcuts for standard user accounts.
Workarounds:
Open the HP 3PAR Management Console from the Management Console folder (<installed
folder>/bin/imc.exe).
Create shortcuts manually.
1.3.3 Adding a Virtual Volume to Windows Fails if the Windows Disk Label Contains
an Apostrophe (Bug 80267)
If the Windows disk label contains an apostrophe, the Add Virtual Volumes to Windows task fails.
Workaround:
Do not use special characters in the disk label.
1.1 Introduction 3