HP 3PAR Solaris Implementation Guide

4 Configuring the HP 3PAR StoreServ Storage for iSCSI
This chapter explains how to establish an iSCSI connection between the HP 3PAR StoreServ Storage
and the Solaris host. For information on setting up the physical connection, see the appropriate
HP 3PAR installation manual.
Configuring the HP 3PAR StoreServ Storage iSCSI Ports
This section applies to configurations based on installed NICs, up to and including 10 Gb port
speed.
NOTE: HP 3PAR StoreServ 10000/7000 Storage supports 10 Gb iSCSI target. HP 3PAR T/F -
Class supports 1 Gb iSCSI target.
Each HP 3PAR StoreServ Storage iSCSI target port that will be connected to an iSCSI initiator must
be set up appropriately for your configuration, as described in the following steps.
The following example shows the default HP 3PAR StoreServ Storage 1 Gb iSCSI port settings,
before configuration:
16 Configuring the HP 3PAR StoreServ Storage for iSCSI