HP 3PAR StoreServ 7450 Storage Service Guide

Adding a Storage System to the Service Processor
After successfully completing the Service Processor Setup Wizard, you must add the storage system
to the configuration database of the SP. Adding the storage system permits the SP to communicate,
service, and monitor the health of the system.
To add the storage system to the SP:
1. Connect the maintenance PC to the SP.
2. In the SPMaint, type 3 and press Enter to select StoreServ Configuration Management.
SPXXXXX
1 SP Main
3PAR Service Processor Menu
Transfer media: ethernet Transfer status: No transfer yet
Enter Control-C at any time to abort this process
1 ==> SP Control/Status
2 ==> Network Configuration
3 ==> StoreServ Configuration Management
4 ==> StoreServ Product Maintenance
5 ==> Local Notification Configuration
6 ==> Site Authentication Key Manipulation
7 ==> Interactive CLI for a StoreServ
X Exit
3
3. Type 2 and press Enter to Add a new StoreServ.
SP - StoreServ Configuration Manipulation
Enter Control-C at any time to abort this process
1 ==> Display StoreServ information
2 ==> Add a new StoreServ
3 ==> Modify a StoreServ config parameters
4 ==> Remove a StoreServ
X Return to the previous menu
2
4. Enter the IP address of the StoreServ and press Enter.
SP - StoreServ Configuration Manipulation
Enter Control-C at any time to abort this process
Please enter the IP address of the StoreServ you wish to add
-OR -
Enter QUIT to abort:
<static.ip.address>
16:57:36 Reply='<static.ip.address>'
Adding <static.ip.address> to firewall rules on interface eth0
50 Installing Storage Software Manually