HP 3PAR StoreServ 7450 Storage Service Guide

5. Enter a valid user credentials (CLI super-user name and password) to add the HP 3PAR StoreServ
and press Enter.
Please enter valid Customer Credentials (CLI super-user name and password) to add
the HP 3PAR StoreServ.
Username:<Valid Username>
Password:<Valid Password>
NOTE: If adding a storage system fails, exit from the process and check the SP software
version for compatibility. Update the SP with the proper InForm OS version before adding
additional systems.
6. After successfully adding the system, press Enter to return to the SP menu.
...
validating communication with <static.ip.address>...
site key ok
interrogating <static.ip.address> for version number...
Version 3.1.x.GA-x reported on <static.ip.address>
retrieving system data for <static.ip.address> ...
HP 3PAR system name <StoreServ Name> found for <static.ip.address>
SYSID <StoreServ Name> found for <static.ip.address>
serial number <StoreServ serial #>found for <static.ip.address>
Writing configuration file for <static.ip.address>...
verifying / adding cli service ids...
Adding StoreServ to NTP configuration...
creating required file structures... adding StoreServ to SP database...
Config complete for <static.ip.address>..
Starting 'spcollect' tasks for StoreServ <StoreServ Name>
Starting 'spevent' task for StoreServ <StoreServ Name>
StoreServ add complete
Press <enter/return> to continue
Exporting Test LUNs
As the final step in verifying the storage system installation, create two or three test LUNs and
confirm that the attached host or hosts can access them. After you have created the test LUNs and
verified that the host can access them, notify the system administrator that the storage system is
ready for use.
NOTE: Before you can export test LUNs, you must determine the host Fibre Channel connection
types and set the appropriate port personas for all target ports, or ports that connect to host
computers. See the HP 3PAR Implementation Guides where appropriate.
Defining Hosts
In order to define hosts and set port personas, you must access the CLI. For more information about
the commands used in this section, see the HP 3PAR OS Command Line Interface Reference.
To set the personas for ports connecting to host computers:
1. In the CLI, verify connection to a host before defining a host:
192.168.46.249 cli% showhost
Exporting Test LUNs 51