HP 3PAR Recovery Manager 1.1.0 Software for Microsoft Hyper-V User Guide (QL226-96343, June 2013)

Table 19 Logout-Rmh parameters
DescriptionOptional/RequiredParameter
Host name of the RMH Server. This is
FQDN or IP address.
Required-RmhServerName
If specified, RMH user along with
Hyper-V host/cluster and Storage
Optional-Remove
System credentials will be removed from
RMH credentials repository.
Configuring RMH Server
The section describes the command line usage and parameters for configuring Hyper-V servers.
Add-HyperV
Add-HyperV adds Hyper-V credentials for users. The command is used with each Microsoft
Hyper-V (cluster or standalone host) credentials and managed by the application.
Preconditions
• User must first log on with Login-Rmh
• Hyper-V name (or synonym) just not already exist
Syntax
Any optional parameters require square brackets [ ] around them.
Add-HyperV -RmhServerName <RmhServerName> -HypervName <HypervName>
-HypervUsername <HypervUser> -HypervPassword <HypervPassword> [-Verbose]
Table 20 Add-HyperV parameters
DescriptionOptional/RequiredParameter
Host name of the RMH Server. This is
FQDN or IP address.
Required-RmhServerName
Hyper V host or cluster name. This is
FQDN or IP address. Synonyms are
checked. The localhost is not supported.
Required-HypervName
Hyper-V username. If cluster, ensure all
controller nodes in the cluster have the
Required-HypervUsername
same username. If not specified, a
dialog box will be presented to enter
credentials.
Hyper-V password. If cluster, ensure all
controller nodes in the cluster have the
Required-HypervPassword
same password. If not specified, a
dialog box will be presented to enter
credentials.
Displays progress messages.Optional-Verbose
Configuring RMH Server 45