HP 3PAR Recovery Manager 1.1.0 Software for Microsoft Hyper-V User Guide (QL226-96343, June 2013)

Syntax
Any optional parameters require square brackets [ ] around them.
Mount-vCopy -RmhServerName <RmhServerName> -HypervName <HypervName>
-VcNameUuid <VcNameUuid> -VmNameUuid <VmNameUuid> [-Timestamp]
[-MountPointPrefix] [-Select] [-HypervHostName] [-HypervUsername]
[-HypervPassword] [-Verbose]
Table 30 Mount-vCopy parameters
DescriptionOptional/RequiredParameter
Host name of the RMH Server. This is
FQDN or IP address.
Required-RmhServerName
Optionally select Hyper-V host/cluster
to use. If not specified, Hyper-V
Required-HypervName
host/cluster must be selected using
Select-Hyperv. This is FQDN or IP
address. Synonyms for Hyper-V are
supported. The localhost is not
supported.
Select VC by name/uuid.Required-VcNameUuid
Select name/uuid to filter VC selection
by Virtual Machine.
Required-VmNameUuid
Specify timestamp of VC to locate in
the format mmddyyhhmmss.
Optional-Timestamp
Mount point prefix where RMH will
create a mount point for each Virtual
Optional-MountPointPrefix
Volume mounted using an appended
mount point name in the format
RMHv.wwn.partition.timestamp
where wwn is WWN of VV mounted,
partition is the partition number, and
timestamp is in format mmddyyhhmmss.
NOTE: If not specified, VVs will be
exported to host by Storage System, but
no mount points will be used. You will
need to access VVs using their volume
guid path (example:
\\?\Volume(wwn)\).
Specifies the virtual hard disk name,
virtual volume name, or virtual volume
Optional-Select
WWN in a comma-separated list. For
virtual hard disk name, this is the full
filename with path, or just a partial
name. Wildcards are not allowed. By
default, RMH will mount all Virtual
Copy volumes in a VCS.
Hyper-V host name. Use this option to
specify host node in cluster. You may
Optional-HypervHostName
also use this option in a non-cluster
environment. If not specified,
HypervHostName is used from
Login-Rmh.
Hyper-V user name. If not specified,
HypervUsername is used from
Login-Rmh.
Optional-HypervUsername
52 Using PowerShell Snap-in Command Line Interface