HP 3PAR VSS Provider 2.2.2 for Microsoft Windows User Guide (QL226-97305, December 2013)
Table Of Contents
- HP 3PAR VSS Provider 2.2.2 Software for Microsoft Windows
- Contents
- 1 Introduction
- 2 Overview
- 3 Installation, Upgrade, and uninstallation
- System Setup
- Installing HP 3PAR VSS Provider for Microsoft Windows
- Verifying the Installation
- Repairing HP 3PAR VSS Provider Installation
- System Registry Values
- Upgrading from a Previous Version
- Verifying the Upgrade
- Removing HP 3PAR VSS Provider for Microsoft Windows
- Using the ProvCfg Command to Set Up or Modify a System Connection
- 4 HP 3PAR Remote Copy Software and HP 3PAR VSS Provider
- 5 Diagnostics
- 6 Support and Other Resources
- 7 Documentation feedback
NOTE: The ProvCfg command output depends completely on the HP 3PAR CLI output.
Hence, the output for invalid or expired certificate might be different from the output shown.
NOTE: You might not see the ProvCfg command output as shown in the image in the
following cases:
◦ If the certificate is already saved for current StoreServ user using HP 3PAR CLI (outside
HP 3PAR VSS Provider)
◦ If an incompatible HP 3PAR CLI is installed on the host.
20 Installation, Upgrade, and uninstallation