HP 3PAR VSS Provider 2.2.2 for Microsoft Windows User Guide (QL226-97305, December 2013)

NOTE:
• For backward compatibility, the default configuration is used for single system architecture.
Use the –default option to set the configuration to default values.
• Any change to the username and password information used to generate the system
authentication information requires a local authentication update using the following command:
ProvCfg StoreServ –sys <sysname> -user <username> -pass <password>
• To add an additional system configuration, use the following command:
ProvCfg StoreServ –sys <sysname> -user <username> -pass <password>
Make sure that the Windows system is connected to the new system via an FC/ ISCSI port
prior to the addition.
• Any change to the Log or StoreServ options using the ProvCfg.exe utility requires that
both the Volume Shadow Copy Service and the HP 3PAR VSS Provider for Microsoft Windows
service be restarted.
• The previous command option InServ is deprecated and will not be supported in future
releases.
• On upgrading or downgrading the firmware version on HP 3PAR StoreServ Storage System,
it must be registered again with the HP 3PAR VSS Provider using ProvCfg command line
utility for re-registration.
• When ProvCfg command is used with - detail option, State column should change to
Broken/Expired if license is invalid or expired.
ProvCfg StoreServ -sys s260.3pardata.com -detail
Using the ProvCfg Command to Set Up or Modify a System Connection 21