HP 3PAR VSS Provider 2.2.2 for Microsoft Windows User Guide (QL226-97305, December 2013)
Table Of Contents
- HP 3PAR VSS Provider 2.2.2 Software for Microsoft Windows
- Contents
- 1 Introduction
- 2 Overview
- 3 Installation, Upgrade, and uninstallation
- System Setup
- Installing HP 3PAR VSS Provider for Microsoft Windows
- Verifying the Installation
- Repairing HP 3PAR VSS Provider Installation
- System Registry Values
- Upgrading from a Previous Version
- Verifying the Upgrade
- Removing HP 3PAR VSS Provider for Microsoft Windows
- Using the ProvCfg Command to Set Up or Modify a System Connection
- 4 HP 3PAR Remote Copy Software and HP 3PAR VSS Provider
- 5 Diagnostics
- 6 Support and Other Resources
- 7 Documentation feedback
Figure 1 HP 3PAR VSS Provider for Microsoft Windows Operation Overview
Host System Requirements
• For the latest Microsoft Windows server and system service pack requirements, refer to the
latest Single Point of Connectivity Knowledge for HP Storage Products (SPOCK) document.
To obtain a copy of this documentation, see http://www.hp.com/storage/spock
• HP 3PAR CLI installation.
For the supported CLI version, refer to the latest Single Point of Connectivity Knowledge for
HP Storage Products (SPOCK) document. To obtain a copy of this documentation, see http://
www.hp.com/storage/spock .
• The Windows logical volume must be configured as a Basic Disk and located on the virtual
volume.
• Microsoft .Net Framework 4.0 or later.
• Microsoft Visual C++ 2010 Redistributable Package.
6 Overview