HP 3PAR Recovery Manager 4.4.2 for Microsoft Exchange 2007, 2010, and 2013 User Guide

Setting Up the HP Data Protector Backup Specification
To use HP Data Protector with Recovery Manager, you must set up a default backup specification.
The backup specification specifies the default mount point and the necessary devices for tape
backup.
1. Open the Data Protector GUI.
2. Select Backup→Add Backup.
3. In the Create New Backup dialog box, select Blank_Filesystem_Backup and click OK.
4. Click Next (do not select any items).
5. Select the device that Data Protector is to use for backups.
6. Click Next until the Manual add... appears.
7. Click Manual add...
8. Select Windows filesystem and click Next.
9. Enter the appropriate client system, mount point, and description. HP recommends:
<server_used_as_backup_client>Client system
C:Mount point
defaultDescription
NOTE: Recovery Manager uses this information only to create a backup template. Recovery
Manager does not use the actual data entered.
10. Click Next until the Finish button appears. Click Finish.
11. Save the backup specification.
When you issue the HpRmCli Exch backup command with the -dl option, use the name
with which you saved the backup specification (e.g., DPbackup) as the value of the -dl
option.
Setting Up HP Data Protector Cell Manager Access
To use HP Data Protector with Recovery Manager, you must enable the system accounts on the
registered client system to access the Data Protector Cell Manager.
1. Open the Data Protector GUI.
2. In the toolbar drop-down list, select Users.
3. Under the Users folder in the left pane, choose admin, and then choose SYSTEM.
4. In the Client system drop-down list on the General tab in the right pane (or General/Properties
of the Data Protector User tab for Exchange 2007), select <Any>.
For more information on installing HP Data Protector, see HP Data Protector documentation.
Configuring Backup Exec
Requirements
• Symantec Backup Exec Media server on Recovery Manager for Exchange backup server
Symantec Backup Exec software1.
2. Symantec Backup Exec Media server user name and password must be same as the HP
3PAR Recovery Manager for Exchange Backup Server, or you must add the current user
to Backup Exec
• Symantec Backup Exec Remote Media server
34 Configuring Backup Software