HP 3PAR OS 3.1.2 MU5 Release Notes

DescriptionItemIssue ID
When HP 3PAR StoreServ 7000 Storage system
is not built to order it means that it is shipped with
Resolved licensing issue on post-ootb pre-license
install wipe.
84307
a license for 8 disks. If such a system goes through
the ootb process to create the admin volume but
the process is restarted before the actual license
key is installed, it does not admit disks on the
second attempt until the license key is removed
manually. This is resolved. The disks can be
admitted in this situation.
The remote copy group must be stopped to ALL
targets before issuing the dismissrcopytarget
command or a kernel error message is displayed.
kernel error message is displayed when
dismissrcopytarget command is issued.
84353
The following issues, found while testing with client
partners, are resolved:
Several issues with CIM API resolved.84384
1. ReturnToStoragePool does not remove the
underlying logical disks of the StorageVolume.
2. ExposePaths with multiple InitiatorPortIDs results
in multiple instances of SPC, one for each
InitiatorPortID. This is resolved. All the
InitiatorPortIDs belong to the same SPC.
3. There are no fixed StorageSetting that can be
used for creating DynamicStoragePool from
primoridal InExtents. This is resolved.
StorageSettings are added, one for each
supported RAID type.
TPD_ControllerConfigurationService.ExposePaths()
fails to map several volumes to a host.
CIM API - ExposePaths fails to map volumes to
a host.
84500
ExposePaths() incorrectly reports that some of the
volumes belong to a different domain even if all
the volumes are in the same domain, as reported
by showvv -listdom command. This is
resolved.
The command Upgradecage of DCS1, DCS2,
and DCN1 cages can fail sometimes due to a
The command Upgradecage sometimes fails
with 3502 error.
85608
timing issue and a 3502 error is displayed. This
is resolved and the operation is tried again in case
of failure.
Improved error message for upgradecage errors
on the HP 3PAR StoreServ 7000 Storage system.
Improve upgradecage failure error.85797
It is necessary to stop both targets on an SLD
system before dismissing a secondary (periodic)
Kernel error occurs when issuing
dismissrcopytarget on SLD system.
85947
target. Failure to do this can result in error on the
primary storage system. In HP 3PAR OS 3.1.2
MU2, this criteria is enforced so that the user
receives an error message if both targets are not
stopped.
The cancellation of a tunesys task during the initial
analysis phase on a system with a large number
When a tunesys task is cancelled, a new task
may not start for an long period of time.
86094
of base volumes can result in tunesys being unable
to restart for a long period of time (over 2 hours
in some cases). This issue is resolved.
Microsoft Windows 2012 PowerShell cmdlet
New-MaskingSet -FriendlyName fails to set
Microsoft Windows 2012 PowerShell cmdlet
New-MaskingSet -FriendlyName fails to
set friendly name.
86127
friendly name because ModifyInstance of SPC
ElementName is not supported. This is resolved.
If a PCM issue on a DCS1, DCS2, or DCN1 cage
generates an alert, and the issue is then resolved
Earlier cage PCM Alerts remain after system
power cycle.
86441
40 HP 3PAR OS 3.1.2 MU2 Release Notes