AB378A Fibre Channel Mass Storage Adapter Installation Guide, December 2005

Fibre Channel Adapter Installation
Verify the Fibre Channel Adapter Installation
Chapter 1
10
The following table lists the Fibre Channel cables that you can use with the AB378A Fibre Channel Host Bus
Adapter.
Verify the Fibre Channel Adapter Installation
1. To verify the adapter installation, enter the command:
ioscan -f
2. Verify that the following drivers appear for each installed adapter. If all drivers display, proceed to the
next section, Verifying Connectivity.
The ioscan output might look like the following. The third column represents the hardware path of the
slot in which the adapter is installed. This path will be different for each installed adapter port.
If the ioscan output is similar to the following:
fc 0/0/10/1/0 UNCLAIMED UNKNOWN
HP-UX detected the adapter, but the drivers are not properly loaded or an older version of the driver is
installed. The current version of the driver can be obtained from the Operating Environment media for 11i v2
or Application Release media for 11i v1.
Table 1-1 Cable Products
LC-LC
C7524A Fibre Channel Cable 2m LC 50/125 duplex M/M
C7525A Fibre Channel Cable 16m LC 50/125 duplex M/M
C7526A Fibre Channel Cable 50m LC 50/125 duplex M/M
LC-SC
C7529A Fibre Channel Cable 2m LC-SC 50/125 duplex M/M Optical
C7530A Fibre Channel Cable 16m LC-SC 50/125 duplex M/M Optical
Adapter/Extenders
C7534A Fibre Channel Adapter SC F/F
Adapter Kit
C7540A Fibre Channel Adapter Kit: Includes 2m LC/SC Cable and F/F extenders
Table 1-2 ioscan -f Output
Class I H/W Path Driver S/W State H/W Type Description
fc 4 0/0/10/1/0 fcd CLAIMED INTERFACE HP AB378-60001 4Gb Single
Port PCI/PCI-X Fibre
Channel Adapter (FC Port 1)