AB378A Fibre Channel Mass Storage Adapter Installation Guide, December 2005

Fibre Channel Adapter Installation
LED Interpretation
Chapter 1
11
If the correct driver is installed, but the adapter does not show in the ioscan output, the driver is not
recognizing the adapter. Contact HP for assistance.
LED Interpretation
Obtaining Card Information after Installation
Example of Card information after Installation
# fcmsutil /dev/fcd4
Vendor ID is = 0x001077
Device ID is = 0x002422
PCI Sub-system Vendor ID is = 0x00103c
PCI Sub-system ID is = 0x0012d6
PCI Mode = PCI-X 133 MHz
ISP Code version = 4.0.151
ISP Chip version = 2
Topology = PTTOPT_FABRIC
Link Speed = 4Gb
Local N_Port_id is = 0x011a00
Previous N_Port_id is = 0x000001
Table 1-3 AB378A LED Interpretation Table
HBA State
Yellow
LED
(4 Gbps)
Green
LED
(2 Gbps)
Amber
LED
(1 Gbps)
Comments
Power OFF OFF OFF OFF Card doesn’t have power
Power ON ON ON ON Card powered on and not initialized
Power ON 1 Flash/s 1 Flash/s 1 Flash/s After firmware initialization AWAITING LINK-UP
All flashing at the same time
Firmware
Fault
2 Flash/s 2 Flash/s 2 Flash/s All three LEDs flash in continuous sequence
1 Gbps Link
UP/ACT
OFF OFF ON
5 Flash/s
ONLINE
IO Activity
2 Gbps Link
UP/ACT
OFF ON
5 Flash/s
OFF ONLINE
IO Activity
4 Gbps Link
UP/ACT
ON
5 Flash/s
OFF OFF ONLINE
IO Activity