KB.15.15

Figure 113 Listings of global RADIUS parameters configured in Figure 112 (page 151)

Connecting a RADIUS server with a server group

Syntax

[no]radius-server host <ip-address>

Adds a server to the RADIUS configuration or (with no) deletes a server from the

configuration. You can configure up to fifteen RADIUS server addresses. The switch

uses the first server it successfully accesses.

Syntax:

aaa server-group radius <group-name> host <ip-addr>

no aaa server-group radius <group-name>host<ip-addr>

Associates a RADIUS server with a server group. Each group can contain up to 3

RADIUS servers. The default group (called radius'), can only contain the first three

RADIUS servers. The default group cannot be edited. The no form of the command

removes the RADIUS server with the indicated IP address from the server group. If

that server was the last entry in the group, the group is removed.

radius <group-name>

The group name of the RADIUS server group. The name has a maximum length of

12 characters. Up to five groups can be configured with a a maximum of three

RADIUS servers in each group. The first group slot is used by the default group.

host ip-addr

The IP address of the RADIUS server used.

152 RADIUS Authentication, Authorization, and Accounting