KB.15.15

Figure 115 Example of configuring for a RADIUS Server with a non-default accounting UDP port

number

The radius-server command as shown in Figure 115 (page 159) above, configures the switch to use

a RADIUS server at IP address 10.33.18.151, with a non-default UDP accounting port of 1750,

and a server-specific key of "source0151".

Reconfiguring the Acct-Session-ID operation (Optional)

Syntax:

aaa accounting session-id < unique | common>

Optional command to reconfigure the Acct-Session-ID mode to apply to the

accounting service type records for a given management session.

unique

Configures the switch to use a different Acct-Session-ID for each accounting service

type. (Default setting)

common

Configures the switch to apply the same Acct-Session-ID to all accounting service

types in the same management session.

For more on these options, see “Acct-Session-ID options in a management session” (page 187).

Figure 116 Accounting configured for the common option

Configure accounting types and controls for sending reports to the RADIUS server

Syntax:

[no] aaa accounting <exec | network | system |

commands | <start-stop | stop-only> radius

[no] aaa accounting command < stop-only | interim-only>

radius

Configuring 159