KB.15.15

Syntax:

show authorization group [group-name]

Displays information about users and command authorization for command groups.

Figure 140 Showing command information for all groups

Specifying the group parameter without any group names displays information for

all configured groups.

Changing RADIUS-server access order

The switch tries to access RADIUS servers according to the order in which their IP addresses are

listed by the show radius command.

NOTE: When you add a new server IP address, it is placed in the highest empty position in the

list.

Adding or deleting a RADIUS server IP address leaves an empty position, but does not change the

position of any other server addresses in the list. For example if you initially configure three server

addresses, they are listed in the order in which you entered them. However, if you subsequently

remove the second server address in the list and add a new server address, the new address will

be placed second in the list.

Thus, to move a server address up in the list, you must delete it from the list, ensure that the position

to which you want to move it is vacant, and then re-enter it. For example, suppose you have already

configured the following three RADIUS server IP addresses in the switch:

Figure 141 Search order for accessing a RADIUS server

Using 179