KB.15.15

event log message (warning) will be logged that relates to this command. The event

log message with be similar to the following:

W 05/22/13 21:02:06 00419 auth: Bypassing the username for Operator and Manager access level

is enabled

NOTE: The protocols SFTP and SCP which are based on SSH will exhibit similar

behavior as SSH. There are no changes required for PCM and IDM.

Switch behavior with Telnet

The behavior of the switch software in different management interfaces when the

disable-username command is enabled.

Telnet example 1

Operator password: Set Manager password: Not set

Operator username: Not set Manager username: Not set

• Entering the operator password will log onto the switch in operator mode.

• Entering the enablecommand in operator mode will provide access to the

switch in manager.

Telnet example 2

Operator password: Not set Manager password: Set

Operator username: Not set Manager username: Not set

• Entering the manager password will log onto the switch in manager mode.

• Entering the enable command in the operator mode will prompt for the

password to be entered for manager mode.

Telnet example 3

Operator password: Set Manager password: Set

Operator username: Not set Manager username: Not set

• Entering the operator password will log onto the switch in operator mode.

• Entering the enable command in the operator mode will prompt for the

password to be entered for manager mode.

• Entering the manager password will log onto the switch in manager mode.

Telnet example 4

Operator password: Set Manager password: Set

Operator username: Not set Manager username: Not set

• Both Operator and Manager Passwords are the same

• Entering the common password will log onto the switch in manager mode

Configuring 239