KB.15.15

NOTE: If a transport error occurs, the switch does not execute the command and the ACL

is not configured.

Figure 198 Using copy tftp command-file to configure an ACL in the switch

3. In this example, the command to assign the ACL to a VLAN was included in the .txt command

file. If this is not done in your applications, the next step is to manually assign the new ACL

to the intended VLAN.

vlan < vid > ip access-group < identifier > in

4. Use the show run or show access-list config command to inspect the switch

configuration to ensure that the ACL was properly downloaded.

Figure 199 Verifying the .txt file download to the switch

5. If the configuration appears satisfactory, save it to the startup-config file:

HP Switch(config)# write memory

Using 287