Access Security Guide K/KA/KB.15.15

[login-failures]
The count of failed CLI login attempts or SNMP management authentication
failures per hour. (Default threshold setting when enabled: 10 med)
[mac-address-count]
The number of MAC addresses learned in the forwarding table. You must enter
a specific value in order to enable this feature. (Default threshold setting when
enabled: 1000 med)
[mac-moves]
The average number of MAC address moves per minute from one port to
another. (Default threshold setting when enabled: 100 med)
[pkts-to-closed-ports]
The count of packets per minute sent to closed TCP/UDP ports. (Default threshold
setting when enabled: 10 med)
[port-auth-failures]
The count of times per minute that a client has been unsuccessful logging into
the network. (Default threshold setting when enabled: 10 med)
[system-resource-usage]
The percentage of system resources in use. (Default threshold setting when
enabled: 50 med)
<1–2147483647>—Set the threshold value
low—Low threshold
med—Medium threshold
high—High threshold
[system-delay]
The response time, in seconds, of the CPU to new network events such as BPDU
packets or packets for other network protocols. (Default threshold setting when
enabled: 3 seconds med)
[trap]
Enables or disables SNMP trap generation. (Default setting when instrumentation
monitoring is enabled: disabled)
To enable instrumentation monitor using the default parameters and thresholds, enter the general
instrumentation monitor command. To adjust specific settings, enter the name of the parameter that
you wish to modify, and revise the threshold limits as needed.
Examples
To turn on monitoring and event log messaging with the default medium values:
HP Switch(config)# instrumentation monitor
To turn off monitoring of the system delay parameter:
HP Switch(config)# no instrumentation monitor systemdelay
To adjust the alert threshold for the MAC address count to the low value:
HP Switch(config)# instrumentation monitor mac-addresscount
low
To adjust the alert threshold for the MAC address count to a specific value:
HP Switch(config)# instrumentation monitor mac-addresscount
767
Configuring 365