Access Security Guide K/KA/KB.15.15
To enable monitoring of learn discards with the default medium threshold value:
HP Switch(config)# instrumentation monitor learndiscards
To disable monitoring of learn discards:
HP Switch(config)# no instrumentation monitor learndiscards
To enable or disable SNMP trap generation:
HP Switch(config)# [no] instrumentation monitor trap
Viewing
Displaying port security settings
Syntax:
show port-security
show port-security port number
show port-security [ port number- port number ] . . . [,port
number]
The CLI uses the same command to provide two types of port security listings:
• All ports on the switch with their Learn Mode and (alarm) Action
• Only the specified ports with their Learn Mode, Address Limit, (alarm) Action,
and Authorized Addresses
Without port parameters,show port-security displays Operating Control
settings for all ports on a switch.
Figure 262 Port security listing (ports A7 and A8 show the default setting)
With port numbers included in the command, show port-security displays Learn Mode,
Address Limit, (alarm) Action, and Authorized Addresses for the specified ports on a switch. The
following example lists the full port security configuration for a single port:
Figure 263 The port security configuration display for a single port
The next example shows the option for entering a range of ports, including a series of non-contiguous
ports. Note that no spaces are allowed in the port number portion of the command string:
HP Switch(config)# show port-security A1-A3,A6,A8
366 Port Security