KB.15.15

Figure 280 show ip source-lockdown status command output

Adding a MAC Address to a port

To simply add a device (MAC address) to a port's existing Authorized Addresses list, enter the

port number with the mac-address parameter and the device's MAC address.This assumes that

Learn Mode is set to static and the Authorized Addresses list is not full (as determined by the current

Address Limit value).

Example

Suppose port A1 allows two authorized devices, but has only one device in its Authorized Address

list:

Figure 281 Adding an authorized device to a port

With the above configuration for port A1, the following command adds the 0c0090-456456 MAC

address as the second authorized address.

HP Switch(config)# port-security a1 mac-address 0c0090-456456

After executing the above command, the security configuration for port A1 would be:

382 Port Security