KB.15.15

HP Switch(config)# ip authorized-managers 10.28.227.101

255.255.255.252 access manager

If you omit the < mask bits > when adding a new authorized manager, the switch automatically

uses 255.255.255.255. If you do not specify either Manager or Operator access, the switch

assigns the Manager access.

To Edit an Existing Manager Access Entry.

To change the mask or access level for an existing entry, use the entry’s IP address and enter the

new value(s). (Notice that any parameters not included in the command will be set to their default.):

HP Switch(config)# ip authorized-managers

10.28.227.101 255.255.255.0 access operator

The above command replaces the existing mask and access level for IP address 10.28.227.101

with 255.255.255.0 and operator.

The following command replaces the existing mask and access level for IP address 10.28.227.101

with 255.255.255.255 and manager (the defaults) because the command does not specify either

of these parameters.

HP Switch(config)# ip authorized-managers 10.28.227.101

To Delete an Authorized Manager Entry.

This command uses the IP address of the authorized manager you want to delete:

This command uses the IP

address of the authorized manager you want to delete:

WebAgent: Configuring IP Authorized Managers

In the WebAgent you can configure IP Authorized Managers as described below.

To Add, Modify, or Delete an IP Authorized Manager address:

1. In the navigation tree, click on Security.

2. Click on IP Authorization.

3. Click on Add Address to add an IP Authorized Manager.Enter the appropriate parameter

settings for the operation you want.

4. To delete an IP authorized Manager, select the Authorized Address and click on Delete.

5. To change IP Authorization parameters, click on Change in the IP Authorization Details box.

Enter the information and click on Save.

Figure 306 Configuring Authorized Manager Access Method in the WebAgent

Configuring 415