KB.15.15

14 Traffic/Security Features and Monitors

Configuring traffic/security

Configuring security settings using the CLI wizard

To configure the security settings using the CLI wizard, follow the steps below:

1. At the command prompt, type setup mgmt-interfaces.

The welcome banner appears and the first setup option is displayed (Operator password).

As you advance through the wizard, each setup option displays the current value in brackets

[ ] as shown in Figure 314 (page 427).

Figure 314 Management Interface wizard configuration

2. When you enter the wizard, you have the following options:

• To update a setting, type in a new value, or press Enter to keep the current value.

• To quit the wizard without saving any changes, press CTRL-C at any time.

• To access online Help for any option, press ?.

After you have gone through each setup option, the wizard displays the summary

configuration together with a prompt to save the changes, see Figure 314 (page 427) for

an example.

Configuring traffic/security 427