Access Security Guide K/KA/KB.15.15
Error messages
Error messages that may occur when executing secure-mode:
Initial check failure message:
This command can only be run on a serial terminal
Possible pre-check failure messages:
• The default boot image is not set.
• The default boot image must be the same image that is running
• Standby Management Module is not responding
• Active and Standby Management Modules are not in sync
• The current software image was downloaded with an older software version and does
not have its signature. Download the image again.
After rebooting:
Secure-mode transition failed. Standby Management Module is not responding.
504 Secure Mode (3800, 5400zl, and 8200zl Switches)