Basic Operation Guide 2014/02

Example 92 The show ip source-interface command Output
HP Switch(config)# show ip source-interface
Source-IP Configuration Information
Protocol | Admin Selection Policy IP Interface IP Address
-------- + ----------------------- ------------- ---------------
Tacacs | Configured IP Interface vlan 22
Radius | Configured IP Address 10.10.10.2
Syslog | Configured IP Interface vlan 10
Telnet | Outgoing Interface
Tftp | Outgoing Interface
Sntp | Outgoing Interface
Sflow | Outgoing Interface
The show ip source-interface detail command displays detailed information about the configured
policies, source IP address, and interface state for each protocol.
Syntax:
show ip source-interface detail [ radius | sflow | sntp | tacacs |
telnet | tftp | syslog ]
Displays detailed operational status information for the source IP address selection
policy. Information about the configured policies, source IP address and interface
state are displayed.
When no parameters are specified, policy information for all protocols is displayed.
Configuring a single source IP address 121