Basic Operation Guide 2014/02

Example 94 The show radius command displaying source IP selection information
HP Switch(config)# show radius
Status and Counters - General RADIUS Information
Deadtime(min) : 0
Timeout(secs) : 5
Retransmit Attempts : 3
Global Encryption Key :
Dynamic Authorization UDP Port : 3799
Source IP Selection : Configured IP address
Example 95 The show tacacs command displaying source IP selection information
HP Switch(config)# show tacacs
Status and Counters - TACACS Information
Timeout : 5
Source IP Selection : Configured IP Interface
Encryption Key :
Example 96 The show debug command displaying source IP selection information for Syslog
HP Switch(config)# show debug
Debug Logging
Source IP Selection: Configured IP interface
Destination: None
Enabled debug types:
None are enabled.
Example 97 The show telnet command displaying source IP selection
HP Switch(config)# show telnet
Telnet Activity
Source IP Selection: 10.10.10.11
-------------------------------------------------------
Session : ** 1
Privilege: Manager
From : Console
To :
Example 98 The show sntp command displaying source IP selection
HP Switch(config)# show sntp
SNTP Configuration
SNTP Authentication : Disabled
Time Sync Mode: Timep
SNTP Mode : disabled
Poll Interval (sec) [720] : 720
Source IP Selection: Outgoing Interface
Configuring a single source IP address 123